Quick Answer: What Is The Default Password For Kkmoon DVR?

How can I fix my DVR problem?

DVR TroubleshootingMake sure your equipment (TV and cable) is properly connected and powered on.Make sure the coax cable is connected to the outlet.Remove any objects around your receiver to allow proper ventilation.Refresh your receiver.Unplug your receiver and wait at least 60 seconds before plugging it back in..

What is Amcrest default password?

adminThe default username and password for Amcrest cameras are “admin” for both. Using the IP address that was found with the Config Tool, log into the camera interface to change your default password.

What is the default password of DVR?

The default passwords for your DVR or NVR are the same as the username. Therefore, the default password for the 888888 User is 888888, the default password for the admin User is admin and the default password for the 666666 User is 666666.

How do I reset my QSEE DVR password?

Step 1 Reset a Forgotten Password using QC View and Email. … Click the drop down option to change the user. … Click on “Forgot Password” … The QC View app is required to reset your password using an email address. … Press the Menu button in the top left corner. … Select “MORE” … Select “Reset Device Password”More items…

What is IP camera activation password?

In earlier versions of the firmware (to version 5.3. 0) IP cameras HIKVISION supplied to IP address 192.0. 0.64 and the default password is 12345. … 0 and above before connecting to the network need to “activate” because they come from the factory without password (not active).

What is the default password for DVR H 264?

123456This method works with some old Swann DVR models, and the factory default password after the reset is 123456.

How do I find my IP camera password?

By default, the IP Camera’s administrator password is admin. And you can change the password on User Management page. If you forget the password, the only way is to reset the IP Camera to factory default setting via hardware reset button.

How do I log into my IP camera?

How to view your IP camera remotely via a web browserOpen a web browser and type the IP address. … Go to SETTING > BASIC > Network > Information to find the HTTP port number used by the camera. … After you change the port, you will need to reboot the camera in order to save the changes. … After you reboot, log back into the camera on your web browser, using.More items…•

What is foscam default password?

After the reset the username will be “admin” and no password(leave the password field blank). After the first login to the camera you will be prompted to enter a new username and password.

How do I find out what model my DVR is?

The serial number and model number are generally found on a sticker on the top or bottom of the DVR / NVR. The serial number is located under the barcode and the model number will display as M/N:.

How do I reset my DVR to factory settings?

Factory Reset InstructionsFirst, make sure that the unit is turned off.Then press and hold any button on the included infrared remote control.While holding the button on the remote, power on the unit.You should hear a single beep followed by a double beep. … Now that the DVR is booted, it will be set to the factory default settings.

How do I connect my H 264 DVR to my iPhone?

dvr h. 264 viewing over safari or iphoneOpen the Safari web browser from your iPhone.Enter your DVRs hostname or IP address, the default port is 7000.Click the login button.